Your ALR network adapter is 100% compatible with the Novell
NE2100 network adapter.  If you already have software included
with your particular network operating system that supports the
NE2100, you can use it for this card.

		*** Microsoft Windows for Workgroups ***
   
When installing Microsoft Windows for Workgroups for this card,
select the Novell NE2100 card when prompted to by Windows for
Workgroups.  IMPORTANT: After Windows for Workgroups has been
installed, you must copy the file AM2100.DOS from this floppy
diskette to the directory on your hard drive where Windows is
stored (typically, C:\WINDOWS).  Then, you must edit your
CONFIG.SYS file to call out the new file.  Here are the
instructions to do this:

1.  After installing Windows for Workgroups for the NE2100, copy
    the file A:\MSLANMAN.DOS\DRIVERS\ETHERNET\AM2100\AM2100.DOS 
    to C:\WINDOWS.

2.  Edit config.sys such that it has the line 
    "device=C:\WINDOWS\AM2100.DOS".


Note:  For the RANGER network adapter, check the example PROTOCOL.INI files
and make sure that your PROTOCOL.INI files match the settings for Interrupt,
I/O Address, and DMA. 


