A Few tips before installing the PCM10 under WIN95.

If you choose to use the PCM10 IDE Interface then you should install
the sound card first then the CD ROM drive.
This is because the install routine adds a line to
the "config.sys" which sets up the CD ROM interface.

If you are using the IDE interface on the PC motherboard then you should
choose the "miroSOUND PCM10" install routine without the IDE interface.

To install the PCM10 under Windows 95 just follow these rules:

1) Open the Control Panel
2) Click the "Hardware" icon. Click "Continue".
3) Answer the question if you want to search for new hardware 
   with "No". Click "Continue".
4) Choose "Sound, video, and game controllers"
5) Choose "Diskette"
6) Select the drive where your driver diskette is located.
   Click "Browse".
7) Select "PCM10.INF" and click "OK". 
8) You can then choose the mode you wish to install
   -  "miroSOUND PCM10" installs everything except IDE
   -  "miroSOUND PCM10 + IDE" miroSOUND PCM10 with 
       CD-ROM support  
        
9) Please reboot the computer.

To activate the miroSOUND PCM10 CD-ROM interface under Windows 95,  
repeat steps 1 and 2. Answer the question under 3) with "Yes". 
Click "Continue". After that, the miroSOUND PCM10 IDE interface
is entered in the system.

Please make sure, that in the CONFIG.SYS file the line:
"DEVICE=C:\WINDOWS\CDSETUP.SYS /T:I" is entered before 
the command line of your CD-ROM driver.
stehen mu.

If you do not hear any sound, check the mixer levels and make sure none
of the channels are muted.

To install the joystick follow the steps 1 - 4 then instead of to "Diskette"
go directly to "miro Computer Products" (within the list of 
manufacturers on the left side) then choose "miro Gameport Joystick Controller". 
Please make sure that you have got the diskette ready.




miro Computer Products AG


